Loading ...
Loading ...
Loading ...
3
Mounting
The camera is designed for mounting behind the license plate of your car
through the screw holes on the license plate. No drilling hole is required.
1. Remove the license plate lamp. Through the opening of the license
plate lamp, run the camera’s cable from the outside into the inside of
the car.
2. Remove the license plate screws. Align the camera frame with two top
screw holes on the license plate, and secure the camera frame with two
license plate screws. Make sure the camera is correctly oriented to
avoid reverse image.
Camera frame
License plate frame
3. Verify the camera angle is properly positioned. If needed, loosen the
screws and adjust the camera angle then re-tighten the screws.
Troubleshooting
Problem Solution
No image Ensure the camera’s power cable is securely plugged.
Ensure there is correct and secure wiring between the
camera and your head unit.
Ensure the reverse input wire on your head unit is
connected to the vehicle’s reverse light.
Ensure correct camera settings on your head unit.
Image blurry Check for water drops or dust on the camera lens.
Clean it with a damp, ber-free cloth.
Image shaking Ensure the camera is tightly mounted.
Image slanted Adjust the camera frame position.
Loading ...
Loading ...