Loading ...
Loading ...
Loading ...
9
DOWN
Used to decrease (cool) the set temperature by 1°C/1ºF.
Indicator Light
The indicator light is the decimal point located at the right lower corner of the display. The indicator
light will be on when a multi-key function is selected. To perform a multi-key function, press and
hold the first key, then press the second key for at least 5 seconds and then release both keys.
ºF/ºCSelector
Select the temperature display setting in Fahrenheit or Celsius degree. To change the temperature
from Fahrenheit to Celsius or from Celsius to Fahrenheit, press and hold the LIGHT key for 5
seconds.
Setting the Temperature Control
• The unit has two separate temperature zones. The temperature of the left zone can be set
between 36ºF and 43ºF (2ºC and 6ºC) which is suitable for storing beverages and the
temperature of the right zone can be set between 41ºF and 68ºF (5ºC and 20ºC) which is
suitable for storing wines.
• When the unit is plugged in for the first time, the unit will power up automatically to the preset
defaults. The preset temperature at the factory for the LEFT temperature zone is 38ºF (3ºC) and
for the RIGHT temperature zone is 54ºF (12ºC).
• You can press the left side UP and DOWN keys to control the internal temperature of the LEFT
temperature zone and press the right side UP and DOWN keys to control the internal
temperature of the RIGHT temperature zone. When you press the two keys at the same time,
the display will show the last temperature set previously.
• The temperature that you desire to set will increase 1ºC or 1ºF if you press the UP key once;
conversely, the temperature will decrease 1ºC or 1ºF if you press the DOWN key once. The
display flashes while you make the setting.
• After the temperature has been set, the display shows the current inner temperature of the
particular temperature zone.
• To view the set temperature at any time, press the UP or DOWN key; the set temperature will
temporarily flash in the display for 5 seconds. Then the display shows the current inner
temperature again.
NOTE:
• If the unit is unplugged, or power is lost or turned off, you must wait 3 to 5 minutes before
restarting the unit. If you attempt to restart before this time delay, the unit will not start.
• When you use the unit for the first time or restart the unit after it has been shut off for a long
time, there could be a few degrees variance between the temperature you select and the one
indicated on the LED readout. This is normal and is due to the length of the activation time.
There should not be a problem once the unit has been running for a few hours.
Loading ...
Loading ...
Loading ...