Loading ...
Loading ...
Loading ...
6
INSTALLATION INSTRUCTIONS
BEFORE USING YOUR APPLIANCE
• Remove the exterior and interior packing.
• CAUTION: After unpacking you MUST allow this appliance to stand upright for at least 2 hours to
allow the lubricant and refrigerant to drain back into the compressor and stabilize. Failure to do so
may adversely affect performance and the lifetime of the unit.
• Clean the interior surface with lukewarm water using a soft cloth.
• Install the handles on the doors. (See page 8.)
INSTALLATION OF YOUR APPLIANCE
• The appliance is designed for built-in, recessed or free-standing installation for indoor use only.
WARNING: Do not store or install the appliance outdoors.
• CAUTION: This appliance, or at least one of its compartments, is designed for storing and cooling
wines. Do not store perishable food, medicine or other medical products in the wine storage
compartment.
• Place your appliance on a floor that is strong enough to support it when it is fully loaded. To level the
unit, adjust the front adjustable legs.
• For freestanding installation, 5” (127mm) of space at the back and sides of the unit and 4“ (102mm) at
the top are suggested, which allows the proper air circulation to cool the compressor and condenser
for energy saving. Even for built-in installation, it is a must to keep at least 3/16” (5mm) of space on
each side, 2” (50mm) at the back and 1/16” (1.6mm) at the top to ensure proper service access and
ventilation. The air vent at the front of the appliance must never be covered or blocked in any way.
• NOTE: Do not install the appliance near an oven, radiator or other heating source. Direct sunlight may
affect the acrylic coating and heat sources may increase electrical consumption. Do not install in a
location where the temperature will fall below 60°F (16°C). For best performance, do not install the
appliance behind a cabinet door or block the base grille.
• Avoid locating the unit in moist areas.
• Plug the appliance into an exclusive, properly grounded wall outlet. Do not under any circumstances
cut or remove the third (ground) prong from the power cord. Any questions concerning power and/or
grounding should be directed toward a certified electrician or an authorized service center.
ELECTRICAL CONNECTION
This appliance should be properly grounded for your safety. The power cord of this appliance is equipped
with a three-prong plug which mates with standard three-prong wall outlets to minimize the possibility of
electrical shock.
Do not under any circumstances cut or remove the third (ground) prong from the power cord supplied. For
personal safety, this appliance must be properly grounded.
This appliance requires a standard 115/120 Volt AC 60Hz three-prong grounded electrical outlet. Have
the wall outlet and circuit checked by a qualified electrician to make sure the outlet is properly grounded.
WARNING
Improper use of the grounded plug can result in the risk of electrical shock. If the power cord is
damaged, have it replaced by a qualified electrician or an authorized service center.
Loading ...
Loading ...
Loading ...