Loading ...
Loading ...
Loading ...
Disposal en
43
Fault Cause and troubleshooting
Buttons are flashing. Condensation has formed behind the control panel.
No action required. As soon as the condensation has evaporated, the buttons no longer
flash.
"Plopping" sounds
can be heard when
cooking with steam.
Water vapour requires the cold/heat effect for frozen food.
No action required.
The appliance hums
during operation and
after it is switched off.
Functional test of the pump creates operating noise.
No action required.
The interior lighting
does not work.
Basic setting has been changed.
▶
Change the basic setting for the lighting.
→"Basic settings", Page27
The LED light is defective.
▶
Call
→"Customer Service", Page44.
A notification appears
on the display con-
firming that the max-
imum operating time
has been reached.
The maximum operating time has been reached. The appliance stops heating.
1.
Press "OK" to confirm the notification about the maximum operating time.
2.
Check whether you still need the appliance.
▶
Set a cooking time so that the operation does not stop.
→"Time-setting options", Page21
The operation stops. The maximum operating time has been reached. The appliance stops heating.
1.
Press to switch off the appliance.
2.
If necessary, press to switch the appliance back on and then restart the operation.
▶
Set a cooking time so that the operation does not stop.
→"Time-setting options", Page21
Error code made up
of letters and num-
bers appears on the
display, e.g. E0111.
The electronics have detected a fault.
1.
Switch the appliance off and on again.
a If the fault was a one-off, the message disappears.
2.
If the message appears again, call the after-sales service. Please specify the exact error
message when calling.
→"Customer Service", Page44
The cooking result is
not satisfactory.
Settings were unsuitable.
Adjustment values, e.g. temperature or cooking time, depend on the recipe, quantity and
food.
▶
Next time, set lower or higher values.
Tip:A lot of other information about the food preparation and corresponding adjustment
values can be found in the HomeConnect app or on our website www.neff-interna-
tional.com.
Disposal
26 Disposal
26.1 Disposing of old appliance
Valuable raw materials can be reused by recycling.
1.
Unplug the appliance from the mains.
2.
Cut through the power cord.
3.
Dispose of the appliance in an environmentally
friendly manner.
Information about current disposal methods are
available from your specialist dealer or local author-
ity.
This appliance is labelled in accord-
ance with European Directive
2012/19/EU concerning used elec-
trical and electronic appliances
(waste electrical and electronic equip-
ment - WEEE).
The guideline determines the frame-
work for the return and recycling of
used appliances as applicable
throughout the EU.
Loading ...
Loading ...
Loading ...