Loading ...
Loading ...
Loading ...
15sharkclean.co.uk14 sharkclean.co.uk
FLOOR NOZZLE
MAINTAINING YOUR VACUUM
CLEANING SOFT ROLLER
FLOOR NOZZLE
If any hair is wrapped around the brushroll, continue cleaning using the Carpet setting on a bare floor surface,
a low-pile carpet, or a small area rug� If some fibres remain wrapped around the brushroll after continued
use, carefully remove them� If you run over a hard or sharp object or notice a noise change while vacuuming,
check for blockages by following the steps under ‘Checking for Blockages in the Floor Nozzle’ on the bottom
right of this page�
MAINTAINING YOUR VACUUM
CHECKING FOR BLOCKAGES
Checking for Blockages in the Handheld Vacuum:
1. Turn o vacuum�
2. Remove the handheld vacuum from the wand�
3. Check all intake openings on the dust cup and remove
any debris or blockage�
Checking for Blockages in the Wand:
Standard Wand:
1. Turn o vacuum�
2. Remove the handheld
vacuum and floor nozzle�
3. Check intake openings for
blockages and debris�
4. Clear away debris and
blockages�
Flexology® Wand:
1. Turn o vacuum�
2. Remove the handheld
vacuum and floor nozzle
from the wand�
3. Check the Clog Access
Hose on the Flexology
section of the wand by
pinching the tabs on both
sides of the hose and
lifting the hose out�
4. Clear any debris and
blockages�
Checking for Blockages in the Floor Nozzle:
1. Turn o vacuum�
2. Detach the wand�
3. Use the edge of a coin to open the three locks on the
bottom of the floor nozzle�
4. Remove the cover and tilt back the neck of the floor
nozzle�
5. Check the opening and remove any debris�
6. Replace the cover by sliding the inserts into the slots, then
pressing down firmly on all sides before turning the locks
clockwise to close, until they click securely into place�
1 To remove Soft Roller from nozzle, pull the Soft Roller out by
the tab�
2 Tap loose debris o the Soft Roller� Use a dry towel to wipe
the Soft Roller clean and to remove any debris caught in the
teeth behind the Soft Roller�
3
Hand wash the Soft Roller as needed� Use only water, and let
air-dry completely, which should take at least 24 hours�
4
Reinsert the Soft Roller�
Loading ...
Loading ...
Loading ...