Loading ...
Loading ...
Loading ...
XMG-100 Series User’s Guide
19
3 Pull out the latch and down to unlock the transceiver (latch styles vary).
Note: Make sure the transceiver’s latch is pushed all the way down, so the transceiver can be
pulled out successfully.
4 Pull the latch, or use your thumb and index finger to grasp the tabs on both sides of the transceiver, and
carefully slide it out of the slot.
Note: Do NOT pull the transceiver out by force. You could damage it. If the transceiver will not
slide out, grasp the tabs on both sides of the transceiver with a slight up or down motion
and carefully slide it out of the slot. If unsuccessful, contact Zyxel Support to prevent
damage to your Switch and transceiver.
5 Insert the dust plug into the ports on the transceiver and the cables.
Figure 13 Removing the Fiber Optic Cables
Figure 14 Opening the Transceiver’s Latch Example
Figure 15 Transceiver Removal Example
3.2 Rear Panel
The following figures show the rear panels of the Switch. The power receptacle is located on the rear
panel of the Switch. Refer to the power supply requirements on the panel.
Figure 16 XMG-105HP
Figure 17 XMG-108
Loading ...
Loading ...
Loading ...