Loading ...
Loading ...
Loading ...
Digital Multimeter
Basic Maintenance
11
5. Place the PCA onto the top shield so that the screw holes align.
6. Place the bottom
shield onto the PCA and secure the assembly
with five Phillips-head
screws. Ensure that the shields are tightly
attached. Properly
fitted shields are
required for the Meter to perform to specifications.
LCD
LCD Mask
ama08f.eps
Figure 2. Removing LCD Mask to Access LCD
Reassembling the Meter Case
To reassemble the Meter case:
1. Verify that the rotary knob and circuit board switch are in the
OFF position, and that
the gasket rem
ains secured to the bottom
case.
2. Place the PCA into the bottom case.
3. Place the case top on the case bottom
.
4. To avoid damaging the battery wire, ensure the wire exits the middle of the battery
compartm
ent.
5. Properly
seat the case gasket and snap the
case halves together above the LCD end.
See Figure 1.
6. Reinstall the three case screws and the battery door.
7. Secure the battery
door by
turning the screw 1/4-turn clockwise.
8. Go to “Perform
ance Tests” later in this document, and perform
the procedures
described.
1.888.610.7664 sales@GlobalTestSupply.com
Fluke-Direct.com
Loading ...
Loading ...
Loading ...