Loading ...
Loading ...
Loading ...
5. Move the knobs up in the direction of the handle until
they stop and you hear a click. Tighten the knobs
fully. (Fig. 36)
To assemble the grass catcher
1. Push the 2 transportation covers out and down. (Fig.
37)
2. Put the top part of the grass catcher onto the lower
part of the grass catcher. Attach the grass catcher
frame with the clips. (Fig. 38)
3. Lift the rear cover.
4. Attach the hooks on the grass catcher to the top
edge of the chassis. (Fig. 39)
To assemble the mulching-kit
1. Lift up the rear cover and remove the grass catcher.
2. Put the mulch plug into the grass discharge channel.
The mulch plug of type A is for LC141i and
LC141C. Type B is for LC141iV. (Fig. 40)
3. Close the rear cover.
4. Replace the blade with the Combi blade, see
To
remove and replace the blade on page 23
.
Operation
Introduction
WARNING: Before you operate the
product, you must read and understand the
safety chapter.
Husqvarna Connect
Husqvarna Connect is a free app for your mobile device.
The Husqvarna Connect app gives extended functions
for your Husqvarna product:
• Extended product information.
• Information about, and help with, product parts and
servicing.
To start to use Husqvarna Connect
1. Download the Husqvarna Connect app on your
mobile device.
2. Register in the Husqvarna Connect app.
3. Do the instruction steps in the Husqvarna Connect
app to connect and register the product.
To set the product in operation position
If the handle is put in transport and storage position (see
To set the product in transport position on page 25
), do
the procedure that follows to put the handle in operation
position.
1. Lift the handle until the lower handle locks into
operation position. (Fig. 41)
2. Move the lower knobs up in the direction of the
handle until they stop and you hear a click. (Fig. 36)
3. Tighten the knobs.
4. Lift the upper handle and tighten the knobs. (Fig. 42)
To set the cutting height
1. Move the cutting height lever rearward to increase
the cutting height.
2. Move the cutting height lever forward to decrease
the cutting height. (Fig. 43)
CAUTION:
Do not set the cutting height
too low. The blades can hit the ground if the
surface of the lawn is not level.
Battery
WARNING: Before you use the battery,
you must read and understand the safety
chapter. You must also read and understand
the operator's manual for the battery and the
battery charger.
Battery status
The display shows the remaining battery capacity and if
there are problems with the battery. The battery capacity
is shown for 5 seconds after the product is switched off
or the battery indicator button is pressed. The warning
symbol on the battery is on when an error has occurred.
See
Battery on page 24
.
(Fig. 44)
LED lights
Battery status
All LEDs are lit Fully charged (75-100%)
LED 1, LED 2, LED 3 are
lit
The battery is 50%-75%
charged
LED 1, LED 2 are lit The battery is 25%-50%
charged
LED 1 is lit The battery is 0%-25%
charged.
LED 1 flashes The battery is empty.
Charge the battery.
To charge the battery
Charge the battery before the first use. The battery is
only 30% charged when supplied to the customer.
20
919 - 011 - 16.08.2023
Loading ...
Loading ...
Loading ...