Loading ...
Loading ...
Loading ...
Troubleshooting
English52
Troubleshooting
Problem Action
The washer stops.
• Plug the power cord into a live electrical outlet.
• Check the fuse or reset the circuit breaker.
• Close the door and press
Start/Pause (Hold to Start) to
start the washer. For your safety, the washer will not
tumble or spin unless the door is closed.
• Before the washer starts to ll, it will make a series of
clicking noises to check the door lock and does a quick
drain.
• There may be a pause or soak period in the cycle. Wait
briey and the washer may start.
• Make sure the mesh lter of the water supply hose at
the faucets is not clogged. Periodically clean the mesh
lter.
• If the washer is not supplied with sufcient power,
the washer temporarily will not drain or spin. As soon
as the washer regains sufcient power, it will operate
normally.
Fills with the wrong
temperature water.
• Fully open both taps.
• Make sure the temperature selection is correct.
• Make sure the hoses are connected to the correct taps.
Flush water lines.
• Make sure your water heater is set to supply hot water
with a minimum temperature of 120 °F (49 °C) at the
tap. Also, check the water heater capacity and recovery
rate.
• Disconnect the hoses and clean the mesh lters. The
mesh lters may be clogged.
• While the washer lls, the water temperature may
change as the automatic temperature control feature
checks incoming water temperature. This is normal.
• While the washer lls, you may notice just hot and/or
just cold water going through the dispenser when cold
or warm temperatures are selected. This is a normal
function of the automatic temperature control feature
as the washer determines the water temperature.
Untitled-13 52Untitled-13 52 2023-06-27 4:22:212023-06-27 4:22:21
Loading ...
Loading ...
Loading ...