Loading ...
Loading ...
Loading ...
22
12. Re-attach the junction box lid using a #2 Phillips screwdriver.
Ensure that wires are not being pinched between the lid and
base of the junction box. Attach Junction box lid with the 4
screws removed in step 3 and ensure lid is fully closed and
snugly attached to base.
A
B
F
C
D
E
G
A. Junction box cable
B. Power cord or Home wiring
C. Wire nuts (3)
D. Junction box lid
E. Screws (4)
F. Cable fittings (2)
G. Junction box base
Final Installation Check
21. Open and close door
22. Align Dishwasher Flush to Cabinet
Align dishwasher flush to cabinet.
23. Check for plumb and adjust legs if needed
A
B
C
A. 5/16" (8 mm) nut drivers or hexsockets
B. Pliers - Adjustable upto 2" (5.0 cm)
C. Small level
Use an adjustable wrench to adjust the front feet and a 5/16"
(8 mm) socket to adjust the rear foot. Raise the dishwasher
to 1/8" (3 mm) of the counter top. Check that the dishwasher
is centered from left to right in the opening. If needed, adjust
the leveling legs until the dishwasher is plumb.
Helpful Tip: If the front leveling feet are hard to adjust,
protect the customer's floor and use an adjustable wrench.
Or alternately, use of 2 or more air shims to temporarily lift
the front of the dishwasher.
26-Jun-2023 08:47:55 EDT | RELEASED
In some European factories the letter "W" of the part code mentioned herein will be automatically
replaced by the number "4000" (e.g. "W12345678" becomes "400012345678")
Loading ...
Loading ...
Loading ...