Loading ...
Loading ...
Loading ...
14
6. Connect a power cable that supplies AC24V or DC48V power source to the power terminal. Alternatively, plug a RJ-45
connector with attached Ethernet cable into RJ-45 Network port of the camera, and then plug the other end to a power
sourcing equipment (PSE). Individually, connect audio in/out and alarm in/out sockets with wires from audio in/out and
alarm in/out devices respectively, if required. Complete the related cables connection.
NOTES:
a. The recommended wire size that can be used with 2-pin Power and 12-pin Audio/Alarm connectors is
limited to 28-20 AWG range.
b. The camera supports power supply failover between PoE and 48 VDC/24 VAC. Power failover is only
supported when the camera is connected to a dedicated auxiliary power supply, 48 VDC/24 VAC. No other
cameras can be connected to this auxiliary power supply. It is OK for the camera to share PoE from a
switch that has other cameras connected to it.
c. As soon as the camera is powered it will start to rotate and configure pan/tilt/zoom.
7. Close the pendant cap and use the T-20 torx star wrench (supplied) to tighten the 3 (T-20) pendant cap screws. Please
pay attention to the locking direction.
8. Fully tighten the camera to the mount by threading the camera one turn past hand tight.
NOTE: For more information about this camera, all resources are available in one location:
https://www.pelco.com/products/cameras/ptz-cameras/spectra-enhanced/
Loading ...
Loading ...