Loading ...
Loading ...
Loading ...
www.kingsbottle.com (USA) ｜www.kingsbottle.com.au (Australia)" 7
Rear of the refrigerator
parts included
B
B
A
1. Area “A” is around 7”W x 2”H ( 180Wx50H mm ). #
This area is located 1.2 inch (30mm) from the edge of the appliance on
top, left or right side (see above image).!
2. “B” refers to the position where the holes for brackets should be drilled.#
Note: “B” should always be inside the area “A”!
3. Position the brackets on the desired location, mark and drill pilot holes for
the screws about 0.32” (8mm) into the appliance. Then use a screwdriver
to tighten the screws all the way into the appliance
Position the appliance in the desired location. Locate wall studs behind the appliance and
mark the location where the bracket lines up with a stud on the back of the appliance. Move
the appliance away from the wall and position bracket on the mark. Mark and drill pilot holes
into the center of the stud with a 3/32” (2.5mm) drill bit. Attach a bracket to the stud with the
long screws provided.
Move the appliance into its final position, taking care to line up the wall bracket close enough
to the bracket on the back of the appliance to strap them together. Thread a strap through the
brackets as shown in the illustration. Tighten the straps until snug. Do not over tighten.
CAUTION: These instructions are not intended to be a substitute for proper supervision. The
manufacturer assumes no liability for improper installation or excessive loads placed on
screws, brackets, or straps.
Straps should be periodically adjusted, tested and replaced.
Instructions to Anchor The Appliance to The Wall
B
INSTALLATION
Loading ...
Loading ...
Loading ...