Fellowes US-5709501 Proteus Laminator Product Manual

Loading ...

THERMAL RE-SET

The machine is supplied with a thermal re-set switch. The switch will activate

when the machine becomes too hot. This condition should not occur during

normal use. To re-set the switch:

 $OORZWKHPDFKLQHWRFRROGRZQIRUPLQXWHV

 8QSOXJWKHPDFKLQHIURPWKHPDLQVXSSO\

 6DIHO\VXSSRUWWKHPDFKLQHWRDFFHVVWKHXQGHUVLGH

 8VLQJD3KLOOLSVVFUHZGULYHURSHQWKHFRYHUSODWH

 8VLQJDSHQLQVHUWWKHSHQWKURXJKWKHKROHDQGSUHVVWKHPHWDOVZLWFK

until it snaps closed.

 5HSODFHWKHFRYHUSODWHDQGVFUHZV

 3RZHURQWKHPDFKLQH

TROUBLESHOOTING

Problem Possible cause Solution

No power

Machine not switched on Switch on machine at rear next to plug inlet and at the wall socket

Main fuse failure Replace fuse

Power cord not fitted correctly Check power cord in receptacle on unit

Ready light does not come on after a

long period

Machine is not heating up Contact service dealer

Pouch does not completely seal the item

Item may be too thick to laminate Pass through the machine again

Temperature setting may be incorrect Check pouch thickness is correctly selected and pass through again

Pouch has waves or bubbles Temperature setting may be incorrect Check pouch thickness is correctly selected and pass through again

Pouch is lost in the machine Pouch is jammed

Select reverse button and pull out the item by hand.

Jamming

Pouch was inserted ‘open end’ first

Pouch was not centered on entry

Pouch was not straight upon entry

Empty pouch was used

Pouch is damaged after lamination Damaged rollers or adhesive on rollers Pass cleaning sheets through the machine to test and clean rollers

Curled or burnt laminations Too hot Reduce temperature or increase speed

Soft or poor lamination Too cold Increase temperature or reduce speed

Rollers not running

Rollers too cold (< 60°c) Wait for rollers to warm-up

"STOP" button may be pressed Press "MOTOR" or "SPEED" button

Unstable lamination temperature Roller electric brush may be broken

Contact service dealer

Cannot select any Mode Circuit board error

Rollers not running & motor is running Loose circuit bolts on gear

Excessive noise Gears worn or damaged

Repeated faint line on lamination Roller damaged

Laminator will not reset Too hot Allow laminator to cool down

405605B_NA_Proteus_All_v1.3.indd 7 5/1/2013 1:32:42 PM

Loading ...

Fellowes US-5709501 Proteus 125 Laminator

Proteus Laminator Product Manual - Page 7