Loading ...
Loading ...
Loading ...
OPERATING THE ICE MAKER
INITIAL SET-UP
1.
Plug the appliance into a 115/120v polarized and grounded wall electrical outlet.
2.
Place the on-off switch in the “I” position.
3.
Make sure the water supply is on. As soon as the inner mechanism reaches the
proper temperature, the icemaker mechanism will fill the mold with water.
4.
The first cubes may be small because of air in the water line. Later cubes will
be of standard crescent type size.
5.
Approximate time for the first cycle is between 30-40 minutes.
6.
Each cycle approximately will take 5 oz of water so you should have a full tray after 11 hours.
IMPORTANT: THROW AWAY ALL ICE CUBES MADE DURING THE FIRST 3 HOURS OF OPERATION.
•
When the ice bucket is full, the ice making mechanism will automatically shut off. If the ice cubes melt,
the ice making mechanism will start again.
•
Ice delivery may be paused by raising the metal arm into an upright position
•
If the icemaker is not used regularly, it is recommended that the ice bucket be emptied periodically to
ensure fresh ice.
•
Sometimes the cubes may appear cloudy. This is due to the rapid freezing of the ice cube. This is trapped
air in the water and does not affect the taste and quality of the ice.
•
The front grille should be kept free of dust and lint to allow free airflow.
Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance.
IMPORTANT: This unit should be defrosted approximately every 4-6 weeks or when frost on the
ice maker walls is excessive or more than ¼" thick. If the ambient temperature is above 100℉
(38℃), defrosting should be done more often, or the ice production will be affected. To defrost,
turn the unit off, remove cubes and keep door open at least two inches.
MAINTENANCE
CLEANING YOUR ICE MAKER
•
Turn the switch control to "off ", unplug the ice maker and remove the bucket.
•
Wash the inside with a warm water and baking soda solution. The solution should be about 2 tablespoons
of baking soda to a quart of water.
•
Wash the bucket with a mild detergent solution.
•
The outside of the ice maker should be cleaned with mild detergent and warm water.
•
The stainless steel components of the door should be cleaned with stainless steel cleaner
•
The condenser coils should be vacuumed when they are dusty or dirty
13
Loading ...
Loading ...
Loading ...