Loading ...
Loading ...
Loading ...
USING HEADPHONES
To listen privately or to monitor sound sources, connect a pair of low-impedance
stereo headphones (not supplied) with a 6.35mm plug into the PHONES jack on
the amplier's front panel.
Please listen safely by following these recommendations:
Do not listen at extremely high volume levels. Extended, high-volume listening
can lead to permanent hearing loss. Always start with the volume control set to a
low level BEFORE you put the headphones on. Gradually increase the volume as
necessary.
CONNECTING TO STANDARD AC POWER
After making all other connections, set the POWER switch to the OFF position.
Then, connect the power cord to a standard AC outlet.
CONNECTING TO 4A/12V DC POWER
You can power the amplier from your vehicle's 12-volt battery.
Connect the supplied DC power cable's barrel plug to the DC 12V IN jack on the
amplier, and then connect the cable's other end to the 12-volt accessory socket
on the vehicle, such as the cigarette-lighter socket.
CAUTIONS:
Please unplug the AC power cord before connecting the DC power cable for
this 12V power usage, and disconnect the DC power cable before plugging in
the AC power cord for AC power usage. The vehicle using this power source
must have a negative ground electrical system. If you are not sure, please
check with your vehicle's dealer.
TURNING THE AMPLIFIER ON
1. Turn on the audio input source equipment connected to the amplier's INPUT
jack.
2. Set all volume levels (MASTER, MIC 1, MIC 2, and PHONO/AUX) to their minimum
settings.
3. Press the power switch to turn the amplier on.
4. Adjust the controls of MIC 1, MIC 2, and PHONO/AUX to achieve the desired
volume and balance.
www.PyleUSA.com
12
Loading ...
Loading ...
Loading ...