Loading ...
Loading ...
Loading ...
![](https://files.manualsfile.com/15616424-2409-20/bg5.png)
5
FUNCTIONAL DESCRIPTION
1. Quick change collet
2. Mode selector
3. Fuel gauge
4. Handle
5. Switch lock-o
6. Paddle switch
7. LED
3
2
1
4
7
6
5
ASSEMBLY
WARNING
Recharge only with the charger
specied for the battery. For spe-
cic charging instructions, read the operator’s
manual supplied with your charger and battery.
Removing/Inserting the Battery
To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
WARNING
Always lock the trigger or remove
the battery pack any time the tool
is not in use.
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
WARNING
Only use accessories specically
recommended for this tool. Others
may be hazardous.
Only use accessories with Maximum Safe Operat-
ing Speed rated at least equal to the maximum
speed marked on the power tool. This speed is
based on the strength of the accessory, allow-
ing for a reasonable measure of safety. It is not
meant to imply a best or most ecient operating
speed. Do not exceed the Maximum Safe Operat-
ing Speed.
Do not touch the accessories with bare hands
immediately after drilling or bung; they may
be hot and could burn skin.
Accessories
Drilling and bung accessories should be protected
from:
• wetness and extreme humidity
• any type of solvent
• extreme changes in temperature
• dropping and bumping
Points, cones and plugs should be stored:
• in an organized way so points, cones, or plugs can
be removed without disturbing or damaging other
points, cones, or plugs
• with their safety information
Points, cones and plugs should NOT be dropped,
rolled or bumped.
Discard points, cones, or plugs that have been
dropped, rolled, bumped, subjected to extreme
changes in temperature, or come into contact with
solvents or wetness.
WARNING
To reduce the risk of injury, always
securely tighten the accessory to
the tire buer and clean mandrels before insert-
ing them into the collet. Otherwise the high-speed
rotation of the tool could force the accessory to
y out of the collet.
Installing Drill Bits into Collet
A 7/16" hex adapter is required to use a drilling bit.
1. WARNING! Remove battery to avoid starting the tool.
2. To attach an accessory, pull the collet out and
hold.
3. Press the 7/16" hex adapter into the collet and
release the collet to lock it in place.
4. To remove the accessory, pull the collet out
and hold.
5. Pull out the 7/16" hex adapter and remove the
accessory. Release the collet.
Installing the Bung Wheel
1. WARNING! Remove battery to avoid starting the tool.
2. Install one of the nuts provided onto the threaded
end of the coupler and tighten the nut securely
with a 9/16" open end wrench.
3. Insert the bung wheel.
4. Insert the washer.
Collet
Coupler
Bung Wheel
Washer
Nuts
5. Install and tighten the second nut securely with a
9/16" open end wrench.
NOTE: Use a 7/16" open end wrench to hold the
coupler to assist in tightening the nut.
6. Reverse the procedure when removing the ac-
cessory.
Loading ...
Loading ...
Loading ...