Loading ...
Loading ...
Loading ...
Part 1 – Introduction
12
Inserting a SD Memory Card
Insert a SD memory card into the SD memory card slot
with the 'microSD' printed facing upward.
micro
SD
Push the SD memory card until it disengages from the
slot, and then pull it out.
Installation
• Check the wall or ceiling to see if it needs to be
reinforced. The camera may fall o if the wall or
ceiling is not strong enough to support its weight.
• Install the camera in a shaded area. If the camera
is installed in direct sunlight, it may be aected
adversely.
1
Detach the protrusion part from the cable rubber
along the dotted line.
2
Make the LAN cable go through the cable rubber
using the protect connector.
It is recommended to use lubricant to move the LAN
cable smoothly.
3
Pull the cable slightly and arrange the rubber as
shown below.
To pass through a thin cable or more than two cables,
it is advised to nish it using silicon to make sure
waterproofed perfectly. (Silicon nishing part — refer
to bottom image.)
Loading ...
Loading ...
Loading ...