Loading ...
Loading ...
Loading ...
10
1.5 I/O Terminal Block
Note the I/O Terminal Block is only supported by GV-MD8700-FD. The
terminal block, located on the back panel of the camera, provides the
interface to one input and one output devices. The I/O terminal block can
be used for applications such as motion detection, event alerts via E-Mail
and FTP, and center monitoring through Center V2 and VSM.
1.5.1 Pin Assignment
The pin assignment for the I/O terminal block:
For the output point, please check if your output device meets the following
Absolute Maximum Ratings before connecting it to the output point.
Breakdown Voltage 277V AC, 30V DC
Continuous Load Current 5A (NO), 3A (NC)
Note: Absolute Maximum Ratings are those values beyond which
damage to the camera may occur. Continuous operation of the camera at
the absolute rating level may affect the camera reliability.
The camera supports one digital input and one digital output of dry contact.
Pin Function
1 Digital Input
2 GND
I/O
123
Figure 1-8
3 Digital Output
For details on how to enable an installed I/O device, see 4.3 I/O Settings,
GV-IPCam Firmware Manual.
Loading ...
Loading ...
Loading ...