Loading ...
Loading ...
Loading ...
6 SECTION 2 — ASSEMBLY & SET-UP
Chute Assembly Options
Refer to Figure 2-1 and proceed to your applicable Chute Control Style on pages 7-14.
Tools Required
• Adjustable Wrench or Socket Set
• Needle Nose Pliers
Handle Assembly
1. Cut cable ties securing chute control rod
to lower handle (if applicable) and set
aside.
2. Loosen the top two lock nuts (a)
securing the upper and lower handle
and remove the two carriage screws (b)
from the lower handle and set aside as
shown in Figure 2-2.
(a)
(a)
(b)
(b)
Figure 2-2
3. On select units, loosen the top wing nuts
(a) securing the upper and lower handle
and remove the two carriage screws (b)
from the lower handle and set aside as
shown in Figure 2-3.
(a)
(a)
(b)
(b)
Figure 2-3
4. Place shift lever in Forward-6 position
(if equipped).
5. Observe lower rear area of equipment
to be sure both cables are aligned and
seated properly in roller guides.
See Figure 2-4.
Figure 2-4
NOTE: On units with Overhead Chute Control
(with Flex Shaft), Four-Way Chute Control, and
Electric Chute Control cut cable ties securing
flex shaft to the lower handle and set the flex
shaft aside. Remove rubber bands securing
cables to carriage screws and cut cable tie
securing shift rod to lower handle. Refer to
Figure 2-1 to help identify your unit.
6. Pivot handle upward and align the tab in
the lower area of the upper handle with
the hole in the lower handle. See Figure
2-5. Follow the instructions applicable
to your handle hardware set-up in Steps
7 and 8 to secure the upper and lower
handles. Remove and discard any rubber
bands, if present. They are for packaging
purposes only.
NOTE: On select units with steel rod
speed selectors, you may need to lower
shift rod to the side slightly to manuever
handle panel over it when pivoting
handle upward.
Figure 2-5
7. On units with the handle set-up shown
in Figure 2-2, attach the two carriage
screws (b) and lock nuts (a) removed
in Step 2. Finish securing the handle
by tightening the top two lock nuts (c)
loosened in Step 2. See Figure 2-6.
(c)
(c)
(b)
(b)
(a)
(a)
Figure 2-6
8. On units with the handle set-up shown
in Figure 2-3, attach the two carriage
screws (b) and wing nuts (a) removed
in Step 3. Finish securing the handle by
tightening the top two wing nuts (c)
loosened in Step 3. See Figure 2-7.
(c)
(c)
(b)
(b)
(a)
(a)
Figure 2-7
Loading ...
Loading ...
Loading ...