Loading ...
Loading ...
Loading ...
14 SECTION 2 — ASSEMBLY & SET-UP
Set-Up
Shear Pins Storage (If Equipped)
On select units, holes are provided in the rear
of the handle panel for shear pin (a) and
bow-tie cotter pin (b) storage as shown in
Figure 2-44. If not provided, make sure to store
them in a safe place until needed.
NOTE: Three stage units come with four (4)
shear pins and bow-tie cotter pins.
(a)
(b)
Figure 2-44
Chute Clean-Out Tool
The chute clean-out tool is fastened to the top
of the auger housing with a mounting clip and
a cable tie at the factory. Cut cable tie before
operating unit. See Figure 2-45.
Figure 2-45
Drift Cutters (If Equipped)
The drift cutters are mounted inverted at the
factory for shipping purposes.
Standard
1. Remove two screws (a) and lock nuts (b)
that secure each drift cutter, and remove
them from the sides of auger housing.
See Figure 2-46.
2. Turn the drift cutters around and
position them as shown in Figure 2-46 to
the outside of the auger housing.
(a)
(a)
(b)
(b)
Figure 2-46
3. Attach drift cutters with screws (a) and
lock nuts (b) removed in Step 1.
Tool-less
1. Remove two carriage bolts (a) and wing
nuts (b) that secure each drift cutter, and
remove them from the sides of auger
housing. See Figure 2-47.
2. Turn the drift cutters around and
position them as shown in Figure 2-47 to
the outside of the auger housing.
(b)
(b)
(a)
(a)
Figure 2-47
3. Attach drift cutters with carriage bolts
(a) and wing nuts (b) removed in Step 1.
Tire Pressure (If Applicable)
NOTE: Not applicable to those units equipped
with airless tires.
WARNING! Under any
circumstance do not exceed
manufacturer’s recommended
psi. Equal tire pressure should be
maintained at all times. Excessive
pressure when seating beads
may cause tire/rim assembly to
burst with force sufficient to
cause serious injury. Refer to
sidewall of tire for recommended
pressure.
The tires are over-inflated for shipping
purposes. Check tire pressure before
operating unit. Refer to tire side wall for tire
manufacturer’s recommended psi and deflate
(or inflate) tires as necessary.
NOTE: Equal tire pressure is to be maintained
at all times for performance purposes.
Adjustments
Chute Assembly
NOTE: Upper chutes on models with Four
Way and Electric Chute Directional Control
are controlled by the Four Way/Electric Chute
Directional Control Joystick. See Figure 3-1.
On units with manual chute tilt, the distance
snow is thrown can be adjusted by changing
angle of chute assembly. To do so:
1. Loosen wing knob found on left side of
chute assembly. See Figure 2-48.
Figure 2-48
2. Pivot chute upward or downward before
retightening wing knob.
Loading ...
Loading ...
Loading ...