Loading ...
Loading ...
Loading ...
- 8 -
To the speaker wires
of your head unit
Gray
White
Red
L+
L-
R+
R-
Blue
Black
Metal frame
of the vehicle
• Using the supplied high-level input wire harness, fasten the black ground wire to the metal frame (chassis)
of your vehicle, and connect the other four colored wires to speaker output wires of your head unit. Make
sure to observe speaker polarity.
• Make sure the speaker wires are securely connected and insulated with electric tape. Run the wires under
the car mats for wire protection.
Power Connection
Important! Connect the power wire to the battery through a fuse (not included).
To the remote output
wire of your head unit
Metal frame
of the vehicle
1
2
Fuse
(not included)
12V
Battery
3
1. Using an 8 gauge (or heavier) wire, connect the GND terminal on the subwoofer to the closest point on the
metal frame (chassis) of your vehicle. Keep the ground wire less than 39” (100 cm) in length.
Remove any paint, rust or dirt from the ground point to provide a clean metal surface to which the end of
the ground wire can be screwed or bolted.
2. Using a 16 gauge (or heavier) wire, connect the REM terminal on the subwoofer to the remote output wire
of your head unit.
If high-level input connection is used, you do not need to connect the remote connection. With high-level
input connection and auto power on feature is activated (using the AUTO POWER ON switch on the
subwoofer), the subwoofer can be turned on or off automatically whenever the connected head unit is
turned on or off.
Loading ...
Loading ...
Loading ...