Loading ...
Loading ...
Loading ...
- 9 -
Remote connection is used to automatically turn on or off the subwoofer every time the connected head
unit is turned on or off.
If your head unit does not have the remote output wire, connect the REM terminal on the subwoofer to the
ignition switch wire of your vehicle. In this case, make sure your head unit is also turned on or off with the
operation of the ignition switch to avoid noise occurrence
3. Using an 8 gauge (or heavier) wire, connect the +12V terminal on the subwoofer to the positive terminal of
the 12V vehicle battery through a fuse (not included). Keep the fuse within 18” (45 cm) of the vehicle battery.
It is important to connect the power supply through a fuse.
Subwoofer Level Control Connection
Remote subwoofer
level control
• Connect the supplied remote subwoofer level control to the REMOTE port on the subwoofer. Use this
remote control to independently adjust sound level output of the subwoofer.
• Install the remote control securely under the dash or in a similar location where using it will not distract the
driver.
Troubleshooting
If you have problems using this product, check the following points before you request service. If you still have
a problem, contact our technical support.
Problem Solution
No power Check that the subwoofer is properly grounded (e.g. clean contact point on
the chassis and secure ground connection).
Check that there is at least 3V DC remote input on the REM terminal.
Check that there is battery power or at least 12V input on the +12V
terminal.
Check all fuses. Replace faulty one with the same type and rating.
If the red LED illuminates, this indicates that the subwoofer in protection
mode. Power off the subwoofer briey, then power it on again.
If high level input connection is used, make sure auto power on feature is
activated by pressing the Auto Turn-On switch on the subwoofer.
Loading ...
Loading ...
Loading ...