Loading ...
Loading ...
Loading ...
Configuration
Configure Average Time and Synchronization 7
7-9
4. Save the configuration settings by pressing the SAVE function key.
5. Press Esc to leave the entry field without changing the setting.
Note
The default address is 0.0.0.0 (factory settings). Addresses can only be
entered in conjunction with IP network addressing (for example, address
193.0.255.4).
Note
Network addresses are available from your network administrator.
Configure Average Time and Synchronization
This configuration concerns important parameters required for the synchronization of the
measuring procedure. To configure these parameters, proceed as follows:
• Call up “Timing & Sync” Setup
• Enter average time
• Select synchronization source
• Set trigger level
• Select slope direction
• Select low-pass filter
• Configure signal output
Timing & Sync Setup
Move the cursor to menu item Timing & Sync Setup and press Enter.
The “Timing & Sync Setup” menu is displayed. The value in column Tavg[s] is
highlighted.
esn020.gif
1.888.610.7664 sales@GlobalTestSupply.com
Fluke-Direct.com
Loading ...
Loading ...
Loading ...