Loading ...
Loading ...
Loading ...
EN
©2021 Hestan Commercial Corporation
21
INSTALLATION
(continued)
ATTACHING CUSTOM DRAWER FRONTATTACHING CUSTOM DRAWER FRONT
1. It may be easier to remove the drawer from the unit (see page 12). Remove 8 screws from the
top and bottom of the special frame as shown below. This will detach the frame from the
assembly.
8 SCREWS
FRAME
LIGHT
PIPE
OVERLAY
FRAME
2. Mount the special frame onto your custom overlay panel. A typical overlay panel is 3/4”
[19 mm] thick. A light pipe is supplied in the kit which helps the red indicator light on the
control shine through the drawer face. The light pipe may be press-fit into the new hole
you drilled into the overlay panel. If your overlay panel is less than 3/4” [19 mm] thick, you
may trim the length of the light pipe as needed, but use caution as the optical material is
brittle.
3. Install the completed overlay and frame to the drawer assembly and re-install the 8 screws you
removed in step 1. Re-install the drawer if you removed it.
LIGHT
PIPE
OVERLAY
3
4
"
16
9
16
"
11
"
Loading ...
Loading ...
Loading ...