Loading ...
Loading ...
Loading ...
5
WARNING
Improper use of the grounded plug can result in the risk of electrical shock. If the power cord is
damaged, have it replaced by a qualified electrician or an authorized service center.
INSTALLATION INSTRUCTIONS
Before Using your Appliance
Remove the exterior and interior packing.
Before connecting the appliance to the power source, let it stand upright for approximately 2 hours.
This will reduce the possibility of a malfunction in the cooling system from handling during
transportation.
Clean the interior surface with lukewarm water using a soft cloth.
Installation of your Appliance
This appliance is designed for free-standing installation for indoor use only.
NOTE: Models ACR51W/NSF456 and ACR52G/NSF456 are the only models approved for built-in use.
Place your appliance on a floor that is strong enough to support it when it is fully loaded. To level the
unit, adjust the front leveling legs.
For a freestanding installation, allow a clearance of 5” (127mm) from the back and sides of the unit and 4”
(102mm) from the top of the unit to allow proper air circulation to cool the compressor and condenser.
If the unit is going to be built into an enclosure, you must still allow at least 1/4” of clear space on both sides and
at the top, and 2” at the back. Take care that the air vents at the front are never covered or blocked in any way.
NOTE: It is recommended that you do not install the appliance near an oven, radiator, or other heating
sources. Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Do not install in a location where the temperature will fall below 60°F (16°C). For
best performance, do not install the appliance behind a cabinet door or block the base grille.
Avoid locating the unit in moist areas.
Plug the appliance into an exclusive, properly grounded wall outlet.
Stabilization Period
Prior to use, the unit shall be allowed to stabilize for at least twenty-four hours.
Electrical Connection
This appliance should be properly grounded for your safety. The power cord of this appliance is equipped
with a three-prong plug which should be used with standard three-prong wall outlets to minimize the
possibility of electrical shock.
Do not under any circumstances cut or remove the third (grounding) prong from the power cord supplied.
For personal safety, this appliance must be properly grounded. Any questions concerning power and/or
grounding should be directed toward a certified electrician or an authorized service center.
This appliance requires a standard 115/120 Volt AC ~60Hz three-prong grounded electrical outlet. Have
the wall outlet and circuit checked by a qualified electrician to make sure the outlet is properly grounded.
When a standard 2-prong wall outlet is encountered, it is your responsibility and obligation to have it
replaced with a properly grounded 3-prong wall outlet.
To prevent accidental injuries, the cord should be secured behind the appliance and not left exposed or
dangling.
Loading ...
Loading ...
Loading ...