Loading ...
Loading ...
Loading ...
8 SECTION 2 — ASSEMBLY & SET-UP
4. Then with the previously removed shoulder
bolts (a) and flange lock nuts (b) secure one side
of the seat and seat bracket. While supporting
the seat, remove the Phillips screwdriver and
secure the other side of the seat. Be careful not
to crimp or damage the wire harness while
installing the seat. See Figure 2-3.
(a)
(b)
(a)
(b)
Figure 2-3
5. Using the harness clip attached to the
harness, secure the excess wire to the fender
by snapping the harness clips in place as
shown in Figure 2-4.
Figure 2-4
Lower Deck Discharge Chute Deflector
WARNING
Never operate the mower deck without the chute deflector
installed and in the down position.
1. Check the mower deck for a shipping brace
that may be holding the chute deflector
upward for shipment. If the brace is present,
it must be removed before operating the
tractor. Holding the chute deflector fully
upward, remove the shipping brace. Lower
the chute deflector and discard the shipping
brace. See Figure 2-5.
Figure 2-5
Installing the Hood Collar (If necessary)
There are three (3) alignment posts (a) on the
hood collar (b) that line up with corresponding
alignment holes (c) in the hood (d). See Figure 2-6.
(a)
(a)
(a)
(a)
(b)
(c)
(c)
(c)
(d)
Figure 2-6
Use these alignment points to properly position
the hood collar (a) and then secure it in place with
the six hex bolts (b) provided in the hardware bag.
See Figure 2-7. Tighten the hex bolts to 102-124
in-lbs.
(a)
(b)
(b)
(b)
(b)
Figure 2-7
Installing the Snap-On Hood Topper (If necessary)
To install the snap-on hood topper (a), line up the
holes on the hood topper (a) up with the tabs (b) in the
hood frame as shown in Figure 2-8. Insert the tabs (b)
into the hood topper and pull back to lock into place.
(a)
(b)
(b)
(b)
(b)
Figure 2-8
Once the hood topper is in place, the two locking
tabs (a) near the rear of the hood need to be
pushed upward to lock the hood topper in place.
See Figure 2-9.
Hood Topper Not Shown for Clarity
Figure 2-9
Installing the Screw-On Hood Topper (If necessary)
Note: Be careful not to damage the headlight
harness when installing the screw-on hood topper.
Set the hood topper up against the top of the
hood with the hood open, and align the holes on
the hood.
Secure the screw-on hood topper (a) from below,
hand-tighten the screws (b) on the rear half of the
hood and then snug them. See Figure 2-10.
(a)
(b)
(b)
(d)
(c)
(d)
Figure 2-10
With the rear screws in place, align the holes in the
hood topper (a) with the holes in the hood (c) and
secure in place with remaining two screws (d). See
Figure 2-10.
Tighten all four screws to 16-24 in-lbs.
Installing the Plenum (If necessary)
Note: Be careful not to damage the headlight
harness when installing the plenum.
To install the plenum (a) onto the hood (b), first
insert the rear tabs (c) as shown in Figure 2-11.
(b)
(a)
(c)
Figure 2-11
Loading ...
Loading ...
Loading ...