Loading ...
Loading ...
Loading ...
7
Work screen
Once the machine is powered on, the screen display boot screen,
about three seconds will display this picture; the machine begins to run,
in the picture on the screen; otherwise, the machine could not start;
Stripping parameter setting: The machine when in standby mode, press
; front length parameter begin to flicker, at this time can directly
enter the number, if the input error, press clear input digital input
again; then press preservation, and a paremeter flicker, until the
front end length, front half stripping, total length, rear half stripping end
length, cutter, knife back all the input completion value; The small of the
knife value is , the deeper of the cutting is; the thicker of the wire is,
Loading ...
Loading ...
Loading ...