Loading ...
Loading ...
Loading ...
5
TROUBLESHOOTING
PROBLEM SOLUTION
ENGINE WILL NOT START, IDLE OR ACCELERATE
Empty fuel tank Fill fuel tank with fuel
Primer bulb wasn't pressed enough Slowly press primer bulb 10 times
Old fuel Drain fuel tank and add fresh fuel mix
Fouled spark plug Replace or clean the spark plug
Air filter is plugged Replace or clean the air filter
Improper idle speed
Adjust according to the Idle Speed
Adjustments section.
ENGINE LACKS POWER OR STALLS
Old fuel Drain fuel tank and add fresh fuel mix
Fouled spark plug Replace or clean the spark plug
SPECIFICATIONS
Engine Type ............................................................................................................. Air-Cooled, 2-Cycle
Displacement ................................................................................................................................. 27 cc
Idle Speed RPM ........................................................................................................... 3,200–4,400 rpm
Operating RPM ............................................................................................................ 6,900-7,200 rpm
Spark Plug Gap .................................................................................................... 0.025 inch (0.635 mm)
Lubrication ..................................................................................................................... Fuel/Oil Mixture
Fuel/Oil Ratio ................................................................................................................................... 40:1
Fuel Tank Capacity ............................................................................................................20 oz. (591 ml)
Approximate Unit Weight (No fuel) ............................................................................. 17.8 lbs. (8.07 kg)
UNIT*
* All specifications are based on the latest product information available at the time of printing. We
reserve the right to make changes at any time without notice.
ELECTRIC STARTER AND POWER START BIT™ FEATURES
This unit is designed to be started with an optional electric starter
or Power Start Bit™ that are sold separately. If choosing to start the
unit using one of these features or have questions please contact
your local retailer or call 1-800-828-5500 U.S, (1-800-668-1238
Canada), for more information and purchasing. You may also go to
www.troybilt.com or www.troybilt.ca
OPTIONAL ACCESSORY
CLEANING
Use a small brush to clean off the outside of the unit. Do not use strong detergents. Household
cleaners that contain aromatic oils such as pine and lemon, and solvents such as kerosene, can
damage plastic. Wipe off any moisture with a soft cloth.
STORAGE
Never store a fueled unit where fumes may reach an open flame or spark.
Allow the engine to cool before storing.
Lock up the unit to prevent unauthorized use or damage.
Store the unit in a dry, well-ventilated area.
Store the unit out of the reach of children.
Long Term Storage
1. Remove the fuel cap, tip the unit and drain the fuel into an approved container. Reinstall the fuel
cap.
2. Start the engine and allow it to run until it stalls. This ensures that all fuel has been drained from
the carburetor.
3. Allow the engine to cool. Remove the spark plug and put 5 drops of any high quality motor oil or
2-cycle oil into the cylinder. Pull the starter rope slowly to distribute the oil. Reinstall the spark
plug.
4. Thoroughly clean the unit and inspect it for any loose or damaged parts. Repair or replace
damaged parts and tighten loose screws, nuts or bolts.
Preparing the Unit for Use after Long Term Storage
1. Remove the spark plug and drain all of the oil from the cylinder.
NOTE: Do not use fuel that has been stored for more than 30 days. Dispose of old fuel according to
federal, state and local regulations.
CLEANING AND STORAGE
WARNING: To avoid serious personal injury, always turn the unit off and allow it to cool
before cleaning or maintaining the unit.
Electric Start Feature
Fig. 9
Loading ...
Loading ...
Loading ...