Loading ...
Loading ...
Loading ...
16 OPERATION
3 Press the battery down into the compartment.
NOTE
• Insert the auxiliary battery completely. If the
auxiliary battery is inserted correctly, the
auxiliary battery icon (*) flashes.
• The auxiliary battery icon (*) in the status
display flashes during charging and then lights
up briefly and turns off to save energy when
charging is complete.
Using the Mop Nozzle
Before Use
• You cannot adjust the rotation speed of the mop
plates on the mop nozzle.
• To prevent product damage, the mop plate will
automatically stop if there are foreign objects
stuck in the plate or if it is subjected to a strong
impact. Turn the appliance off immediately and
remove the foreign objects or obstructions
before resuming use.
• If you hear a noise while mopping, the mop pad
may have dropped off the mop plate. Turn off
the product immediately and reattach the pad to
the mop plate before resuming use.
• Do not use a soiled mop pad to clean floors.
• Use only authorized LG Electronics mop pads.
Using the Mop Nozzle
This accessory is only available on some models.
When the mop nozzle is attached, the suction is
turned off and only the mop function operates.
Press the Power
t button to turn the mop on/off.
CAUTION
• Do not assemble or disassemble the nozzle while
the appliance is turned on. Doing so may result
in injury.
• Do not let the appliance stand on the floor while
the wet mop pads are attached. Doing so may
result in damage or swelling of wood flooring.
• Do not use on PVC or polyurethane mats for
infants or children. Friction can cause the motor
to overheat.
NOTE
• If you use the mop nozzle for a long time, the
motor may overheat. (Recommended maximum
run time is 80 minutes.) If the motor overheats, a
safety function is activated and the appliance
automatically turns off. Set the appliance in a
cool, well-ventilated place and allow it to cool
down for about an hour before resuming use.
Filling the Water Tank
Before mopping, you must fill the water tank and
attach it to the mop nozzle.
1 Press the PUSH button a to remove the
water tank from the mop nozzle.
2 Open the water inlet cap b and fill the tank
with water using the water tank filler c.
• If adding detergent, make sure it is fully
diluted in the water and is suitable for
cleaning the floor.
Loading ...
Loading ...
Loading ...