Loading ...
Loading ...
Loading ...
TiX620, TiX640, TiX660, TiX1000
Users Manual
1-26
Data Transmission to the Computer
Use the SmartView
®
software to enable the transmission
of data via the GigE Vision communications protocol.
Another data transmission method is to read out the
SDHC card by means of a card reader.
Set-Up
Hand Strap
The thermal imager is designed as highly portable system
for single-hand operation. Initially, adjust the hand strap
attached to the handle piece as required. For this, open
the loop of the hand strap and adjust the length of the belt
strap in such a way that you can comfortably access the
controls with your fingers. Then, close the hook and loop
fastener of the loop.
Tripod
The thermography camera is equipped with a 4.5 mm
(1/4") tripod thread (DIN 4503) on the bottom of the
housing. To achieve rigid camera images, particularly for
the SuperResolution mode, Fluke recommends that you
attach the thermal imager to a tripod.
Caution
Do not exceed the maximum penetration
depth of the tripod thread: 4.5 mm (DIN
4503).
Power Supply
When using a rechargeable battery, you must place the
battery on the included adapter plate. Push down the
rechargeable battery until it engages. Push the
rechargeable battery slightly to the front, towards the
lens. Please only use the genuine SONY
®
rechargeable
batteries NP-QM91D and the included charger.
The ac adapter is connected to the 14-pin socket on the
right-hand side of the backside of the thermography
system.
Memory Card
The SD card slot is located on the left-hand side of the
camera. In order to guarantee the degree of protection
IP54, the slot is protected by a cover. Pull off the cover to
insert a memory card and insert the SD card into the card
slot. Please observe the proper orientation of the card (▲
to the top). Afterwards, the cover must be re-closed. This
is the only way to ensure the complete degree of
protection of the device.
1.888.610.7664 sales@GlobalTestSupply.com
Fluke-Direct
.com
Loading ...
Loading ...
Loading ...