Loading ...
Loading ...
Loading ...
15SECTION 3 — CONTROLS & OPERATION
• Squeeze the right trigger control to turn
right.
• Squeeze the left trigger control to turn
left.
CAUTION: Operate the snow
thrower in open areas until you
are familiar with these controls.
4-Way Chute Directional Control
Joystick
(If Equipped)
The 4-Way chute directional control joystick is
located on the left side of the dash panel.
• To change the direction in which snow
is thrown, squeeze the button on the
joystick and pivot the joystick to the
right or to the left. See Figure 3-7.
• To change the angle/distance which
snow is thrown, pivot the joystick
forward or backward.
Figure 3-7
Overhead Chute Directional Control
(If Equipped)
The overhead chute directional control is
located at the rear of the snowthrower towards
the left side of the unit under the handle panel.
To change the direction in which snow is
thrown, rotate chute directional control.
See Figure 3-8.
Figure 3-8
Electric Chute Directional Control
Joystick
(If Equipped)
The electric chute directional control joystick
is located on the right side of the dash panel.
Refer to Figure 3-9.
• To change the direction in which snow is
thrown, move the joystick to the right or
to the left.
• To change the angle/distance which
snow is thrown, pivot the joystick
forward or backward.
DIRECTIONAL CONTROL
ELECTRIC CHUTE
CHUTE
ROTATE
LEFT
CHUTE
ROTATE
RIGHT
CHUTE TILT UP
CHUTE TILT DOWN
Figure 3-9
Manual Chute Directional
Control
(Equipped on units with Electric
Chute Directional Control
Joystick)
Proceed as follows to utilize manual chute
directional control if needed:
1. Remove cotter pin (a) from either of the
holes furthest from the chute assembly
on chute rotation assembly.
2. Push in chute control rod until the hole
in it lines up with the third hole in chute
rotation assembly. See Figure 3-10.
(a)
Figure 3-10
3. Reinsert cotter pin (a) through this hole
and chute control rod as shown in
Figure 3-10.
4. Grasp indented portion of chute control
rod and manually rotate chute assembly
to the right or to the left. See Figure 3-11.
Figure 3-11
Overhead Chute Directional Control
(With Flex Shaft)
(If Equipped)
The overhead chute directional control is
located at the rear of the unit towards the
left side under the handle panel. To change
direction in which snow is thrown, rotate chute
directional control. See Figure 3-12A.
CHUTE DIRECTIONAL CONTROL
DISCHARGE
LEFT
DISCHARGE
RIGHT
CHUTE TILT
DOWN
CHUTE TILT
UP
Figure 3-12
Two-Way Chute-Pitch Control™
(If Equipped)
The two-way chute-pitch control is located on
the left side of the dash panel and is used to
control the distance of snow discharge from
the chute.
• To change the upper chute angle to
control the distance that snow is thrown,
pivot the lever forward or backward.
• Move the lever forward to pivot the
upper chute down and reduce the
distance snow is thrown.
See Figure 3-12B.
• Move the lever rearward to pivot the
upper chute upward and increase the
distance snow is thrown.
A B
Loading ...
Loading ...
Loading ...