Loading ...
Loading ...
Loading ...
RIGOL Chapter 2 To Set the Vertical System
2-12 MSO7000/DS7000 User's Guide
Figure 2-3 Label Editing Interface
For example, set the label to "
". In the virtual keypad, rotate the multifunction
knob
to select "Caps" and press down the knob to switch the uppercase or
lowercase mode. Rotate the multifunction knob and select "C", press down the knob.
Then, in the input selection area, rotate the multifunction knob and select "C". Press
down the knob to input "C". Use the same method to input "hn1". After finishing the
input, press OK to finish the editing. You can also enable the touch screen to operate
by touch gestures. If Display is enabled, the label will be displayed at the left
of CH1 waveform.
To delete or modify the input characters, rotate the multifunction knob or enable
the touch screen to realize it.
Rotate the multifunction knob
: use the delete key to delete or modify the
characters. To modify the characters, input the desired characters again.
Enable the touch screen: use the touch gestures to directly move the cursor to
the right side of the character required to be deleted or modified, and then tap
the delete key to delete the character. To modify the characters, input the
desired character again or delete the character.
Label Input Area Input Selection Area Virtual Keypad Delete Key
Upper-lower
Case Switch
Loading ...
Loading ...
Loading ...