Loading ...
Loading ...
Loading ...
Deleting a Particular Record
Use the procedure below to delete a selected
data record.
1. Enter the Recall Mode.
l
Navigating Between Modes
2. Press (A) to display the number of the
measurement you want to delete.
●
Each press of (A) advances to the next
measurement number.
Record number
3. Hold down (B) and (D) for at least two
seconds. Release when [CLR] stops
flashing.
This deletes the displayed data.
Note
●
You cannot delete data while an
elapsed time measurement operation
is in progress.
Deleting All Records
You can use the procedure below to clear all
data records in watch memory.
Important!
●
The all record delete operation cannot
be performed while a stopwatch
measurement operation is in progress.
1. Enter the Recall Mode.
l
Navigating Between Modes
2. Hold down (B) and (D) for at least five
seconds. Release when [CLR ALL] stops
flashing.
[CLR] flashes and then stops flashing to
indicate that the displayed data record
was deleted. Keeping the buttons
depressed will cause [ALL] to flash and
then stop flashing to indicate that all data
has been deleted.
Timer
The timer counts down from a start time
specified by you. A beeper sounds when the
end of the countdown is reached.
●
The beeper will not sound if the battery is
low.
Using CASIO WATCHES to
Configure Timer Settings
If the watch is paired with a phone, you can
also use the CASIO WATCHES phone app to
set the timer start time.
l
Configuring Watch Settings
Setting the Countdown Start
Time
The start time can be set in 1-second units up
to 60 minutes.
●
If a timer countdown operation is in
progress, reset the timer to its current start
time before performing this operation.
l
Using the Timer
1. Enter the Timer Mode.
l
Navigating Between Modes
2. Hold down (A) for at least two seconds.
This causes the minutes digits to flash.
Minutes
3. Use (B) and (D) to change the timer
minutes setting.
●
Holding down (B) or (D) scrolls through
settings at high speed.
Watch Operation Guide 3552
22
Loading ...
Loading ...
Loading ...