Loading ...
Loading ...
Loading ...
7
BLOWER FUNCTION:
Your Bennett Read Tough 12 has an additional function that allows you to blow away leaves and
grass that collect on your covered patio areas, or sawdust in home workshops. Simply plug in and
blow the dirt away.
Setting up your Bennett Read Tough 12 to use the blower function:
1. Remove the Motor Unit (2) from the
Dirt/Water Tank (4) by pushing the Locking
Clips (3) outwards
2. Ensure that the Filter Bag (16) is securely
installed in place (see page 4 & 5 for Dry
Vacuuming)
3. Replace the Motor Unit and secure the
Locking Clips
5. Insert the small end (opposite end to handle)
of the Flexi-Hose (10) into Blower Function
Hose Port (7), turn clockwise to lock in place
9. Plug the Power Cable (9) into a wall socket
10. Switch your Tough 12 on using the Power Switch (1)
11. Vacuum the wet spill / liquid* from surface using a pulling action (squeegee blade at front)
12. When you are done, disconnect the Flexi-Hose (10) from the Motor Unit (2) by grasping the
end of the hose nearest the Hose Port (5), turning it anticlockwise and then pulling the hose
outward
13. Take the Dirt/Water Tank (4) to a sink or disposal area
14. Push the Locking Clips (3) outwards to unlock the Dirt/Water Tank
15. Lift the Motor Unit (2) from the Dirt/Water Tank and place it carefully on the ground
16. Carefully pour out the liquid from the Dirt/Water Tank
17. Rinse the Dirt/Water Tank under running water and dry it completely
* WARNING: Do not vacuum up boiling hot, flammable or combustible liquids
* Your Bennett Read Tough 12 is equipped with a float valve located at the bottom of the motor
unit which will partially shut off the suction as soon as the tank reaches capacity. Immediately
switch off the machine and empty the tank before continuing.
7. Replace the Motor Unit (2) and secure the Locking Clips (3) in place
8. Insert the Flexi-Hose (10) into the Vacuum Function Hose Port (5) and turn clockwise to lock in
place
5. Attach the Wet Floor Nozzle Attachment (14)
to the Floor Nozzle (13) as shown below:
6. Attach the Floor Nozzle to the Extension
Wand (12):
5
Squeegee blade at front
https://manual-hub.com/
Loading ...
Loading ...
Loading ...