Emilia EMF69E 60cm Stainless Steel Electric MultiFunction Oven

User Manual - Page 15

For EMF69E.

PDF File Manual, 20 pages, Read Online | Download pdf file

Loading ...
Loading ...
Loading ...
15
OVEN INSTALLATION - Only by an authorised installer. This is a Warranty condition.
Electrical connection
MODELS EMRENT65/EMF65EN require min 16A fuse rating. Max power rating 2300W 9.6A
MODEL EMF69E requires min 16A fuse rating. Max power rating 3200W 15A
WARNING
To avoid any potential hazard, you must follow our instructions when you install your oven. Failure to install the oven
correctly could invalidate any warranty or liability claims and lead to prosecution.
This oven must be installed by an authorised person according to all codes and regulations as stated in the local
municipal building code and other relevant statutory regulations.
Wiring connections must be in accordance with AS/ NZS 3000 Wiring Rules and any particular conditions of the
local authority.
Refer to data plate for rating information. The data plate is positioned inside the oven door.
Disconnection in the fixed wiring must occur in accordance with the AS/NZS3000 wiring rules. Wiring should be
protected against mechanical failure. Refer to AS/NZS3000. A means of disconnection with a contact separation
of at least 3mm must be supplied in the fixed wiring.
The electrical supply must be appropriate and 240V 50Hz.
The fuse and electrical wiring of the home must support the load of the oven.
The oven must be earthed. Connect the oven to a properly earthed and rated power socket, as appropriate. If a
socket needs to be installed or relocated this must be done by an authorised licensed electrician.
In New Zealand the oven must be connected to the supply by a supply cord fitted with the appropriately rated
plug that is compatible with the socket outlet fitted to the final sub circuit in the fixed wiring that intended to
supply the oven.
The Flexible cord of the ovem must not be subject to direct heat and must be positioned after installation so its
temperature does not exceed 75C.
After electrical connection perform a test on the oven following the instructions of this manual. If the oven does
not function disconnect it from the electrical supply and contact our service team.
Positioning the oven
The oven is designed to be a built in fixture. The dimensions must be as per the dimensions in the diagrams. When
positioning the oven do not use the door as a lever to insert the oven into the fixture and do not place excessive
pressure on an open door.
When installing the oven ensure that the supply cable does not kink.
The cabinet must be capable of withstanding a temperature 70C. Installation into low temperature tolerant
cabinetry eg vinyl coated may result in of the low temperature coating by discolouring or bubbling. If the oven is
to be installed adjacent to vinyl wrapped surfaces used the appropriate installation kit. The manufacturer does not
accept responsibility for damage caused by installation into low temperature tolerant cabinets.
After installation, test and ensure the oven is operating correctly before handing it over to the customer.
Loading ...
Loading ...
Loading ...