Loading ...
Loading ...
Loading ...
21
ELECTRICAL CONNECTION
• The installation of this appliance and the connection to the electrical network should be
entrusted only to an electrician perfectly to the fact of the normative regulations and which
respects them scrupulously.
• The electrical parts should always be protected after the installation.
• The appliance should be connected using a multipolar circuit breaker.
• If the appliance is not fitted with an accessible plug, disconnecting means must be
incorporated in the fixed installation, in accordance with the installation regulations.
• The inlet hose must be positioned so that it does not touch any of the hot parts of the
cooktop or oven.
Caution!
This appliance must only be connected to a network 200-240 V~ 50/60 Hz. Always connect the
ground wire
USE ONLY UL LISTED OR CSA APPROVED COMPONENTS
Connection of the cooktop
Use the brass bridges which are in the connection box to bridge terminals 1-2 and terminals 4-5.
Connect phase 1 to the terminal 1, phase 2 to the terminal 3, phase 3 to the terminal 5 and the
ground to terminal
Caution! Ensure that the cables are correctly inserted and tightly screwed down.
POSITION OF NAMEPLATE
The nameplate is located under the cooktop, as shown on the picture below. When ordering parts
for or making inquiries about your cooktop, always be sure to include the model and serial
numbers and a lot number or letter from the serial plate on your cooktop.
Mains Connection Cable diameter
Protection
calibre
Flexible conduit
200-240 V~ 50/60 Hz
3 Phases 4 x 8 AWG 50 A
¾”
We cannot be held responsible for any incident resulti
ng from incorrect connection or
which could arise from the use of an appliance which has not been earthed or has been
equipped with a faulty earth connection.
Nameplate label
Loading ...
Loading ...
Loading ...