Loading ...
Loading ...
Loading ...
Slide the spring up the cable to expose the cable coupler 2.
threads and lock nut. Refer to Fig. 3-13.
Adjust the lock nut as follows: If adjusting the drive 3.
cable, thread the lock nut outward (down the coupler) to
lengthen the cable and allow the unit to move freely when
the control is released. Thread the lock nut inward (up
the coupler) to shorten the cable to reduce slippage and
prevent the machine from being easily moved with the
drive control engaged.
WARNING! Do not over-tighten the cable. Over-
tightening may prevent the auger from disengaging
and compromise the safety of the snow thrower.
If adjusting the auger cable, thread the lock nut down to 4.
lengthen the cable as necessary to stop the auger from
turning when the control is released.
Securely hook the cable’s spring into the rear most hole of 5.
the respective actuator bracket.
Repeat the wheel drive and auger control tests to verify 6.
proper adjustment. Repeat previous steps if necessary to
attain proper adjustment of each cable
Figure 3-13
12 se c t i O n 3— as s e M b l y & se t -up
Loading ...
Loading ...
Loading ...