Loading ...
Loading ...
Loading ...
7
BATTERY WARNING: Lights red if your UPS self-test (initiated with the Mute/Test Switch) reveals a low battery charge or
internal fault. If this light turns on, let the UPS charge for 12 hours then perform a second self-test. If the light stays on,
contact Tripp Lite for service.
Basic Operation
Other UPS Features (Rear Panel)
AC Receptacles
Your UPS features 15-amp, 20-amp and 30-amp AC outlets. These output receptacles provide your connected equipment
with AC line power during normal operation and battery power during blackouts and brownouts. The UPS protects equipment
connected to these receptacles against damaging surges and line noise. If you have a serial or USB connection to your
UPS, you can remotely reboot connected equipment by turning the UPS OFF and ON using Tripp Lite’s PowerAlert
®
Software.
Selected outlets may be remotely switched OFF and ON individually using Tripp Lite UPS software without interrupting power
to equipment connected to the other outlets. The UPS also features unswitched outlets, which may not be individually
switched OFF. See software instructions for details.
15 amp NEMA
5-15R
20 amp NEMA
5-20R
30 amp NEMA
L6-30R
30 amp NEMA
L14-30R
Smart DB9 Ports
Your UPS features 2 DB9 ports that may be used to connect the UPS to a DB9 port on any workstation or server. Use with
Tripp Lite cabling and PowerAlert Software to monitor and manage network power and automatically save open files and shut
down equipment during a blackout (see Connection.) The DB9 port labeled “SNMP Config” is also used while
configuring Tripp Lite SNMP Adapters.
Smart USB Ports
Your UPS features 2 USB ports that may be used to connect the UPS to a USB port on any workstation or server. Use with
Tripp Lite cabling and PowerAlert Software to monitor and manage network power and automatically save open files and shut
down equipment during a blackout (see Connection.)
EPO (Emergency Power Off) Port
Your UPS features a EPO port that may be used to connect the UPS to a contact closure switch to enable emergency inverter
shutdown. (See Connection.)
Accessory Slot
Remove the small cover panel from this slot to install optional accessories to remotely monitor and control your UPS. Refer
to your accessory’s manual for installation instructions. Visit tripplite.com for more information, including a list of available
SNMP, network management and connectivity products.
External Battery Connector
Use to connect your UPS to an external battery pack. The specifications section of this manual lists the Tripp Lite external
battery packs that are compatible with your model. Refer to the instructions provided with the battery pack for complete
connection information and safety warnings.
Loading ...
Loading ...
Loading ...