Loading ...
Loading ...
Loading ...
INITIAL INSTALLATION
7
Remove pin (D) and clip (E) from downrod (C).
Partially loosen preassembled set screws and nuts
in yoke at top of motor assembly (I).
5a.
5A
E
5B
C
Set Screw
Sideview
D
Yoke
6.
Insert downrod (C) through canopy (F), canopy
cover (G) and yoke cover (H). NOTE: Canopy
cover (G) must be turned with the shiny side
toward the motor assembly (I).
Then, thread wires from motor assembly (I)
through downrod (C).
6
F
H
7.
Slip downrod (C) into motor assembly yoke, align
holes and re-install pin (D) and clip (E). Tighten
set screws in motor assembly yoke and then
tighten preassembled nuts on the set screws.
Then, slide yoke cover (H) down until it rests on
top of motor assembly (I).
7
C
I
H
D
E
Yoke
E
D
Set Screw
and Nut
Sideview
C
5b.
I
G
Loading ...
Loading ...
Loading ...