Loading ...
Loading ...
Loading ...
35
SÍMBOLO WIFI FIJO
Signica que las características WiFi están activas Y
que se ha encontrado la
Home WLAN
PARPADEO LENTO
Signica que el aparato está buscando la
Home
WLAN
.
PARPADEO RÁPIDO
Signica que la
Home WLAN
no se ha encontrado o
que aún no se ha establecido.
ICONO “CONTROL APP”
Cuando aparece el icono CONTROL APPA signica
que la última orden se ha recibido vía app.
Si los ajustes memorizados de la
Home WLAN
deben cambiarse
siga los siguientes pasos:
a) En el panel de control mantenga pulsado unos 20 segundos
un botón MODE C2 hasta que se emita una señal acústica
prolongada.
b) use la app para introducir las nuevas conguraciones WLAN
en la unidad.
REGULACIÓN DEL TEMPORIZADOR
El temporizador es una función que solo se puede activar desde
la App: permite muchas posibilidades de programación, optimi-
zando de esta forma los tiempos de uso del aparato evitando
derroches de energía, congurando el retraso del encendido o
el apagado automático.
FCC AND CANADA EMC COMPLIANCE
INFORMATION
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, includ-
ing interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harm-
ful interference to radio or television reception, which can
be determined by turning the equipment o and on, the
user is encouraged to try to correct the interference by one
or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and re-
ceiver.
• Connect the equipment into an outlet on a circuit dierent
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
Approved under the certication provision of FCC Part 15 as a
Class B Digital Device.
Caution: Changes or modications not expressly approved by
the manufacturer could void the user’s authority to operate
this device.
Caution: To comply with the limits of the Class B digital device,
pursuant to Part 15 of the FCC Rules, this device is to com-
ply with Class B limits. All peripherals must be shielded
and grounded. Operation with non-certied peripherals
or nonshielded cables my result in interference to radio or
reception.
This Class B digital apparatus complies with Canadian ICES-003.
CAN ICES-3 (B)/NMB-3(B)
Cet appareil numérique de la classe B est conforme à la norme
NMB-003 du Canada.
WIRELESS TRANSMITTER COMPLIANCE INFORMATION
The term “IC:” before the radio certication number only signi-
es that Industry Canada technical specications were met.
Le terme «IC:» avant le numéro de certication radio signie seulement
que les spécications techniques d’Industrie Canada ont été respectées.
This device complies with Industry Canada’s licence-exempt
RSSs. Operation is subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including inter-
ference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada ap-
plicables aux appareils radio exempts de licence. L’exploitation est
autorisée aux deux conditions suivantes :
(1) l’appareil ne doit pas produire de brouillage;
(2) l’utilisateur de l’appareil doit accepter tout brouillage ra-
dioélectrique subi, même si le brouillage est susceptible d’en
compromettre le fonctionnement.
This equipment complies with FCC and IC radiation exposure
limits set forth for an uncontrolled environment. This equipment
should be installed and operated with minimum distance 20cm
between the radiator and your body. This transmitter must not
be co-located or operating in conjunction with any other an-
tenna or transmitter.
Cet appareil est conforme à FCC et IC l’exposition aux rayonnements
Loading ...
Loading ...
Loading ...