Loading ...
Loading ...
3
Quick Installation
1
Connect your computer to the UPS, and
the UPS to an electrical outlet.
1. Unplug your computer’s power cord from both
your AC outlet and your computer’s AC input.
2. Insert the female plug of the power cord that
came with your UPS
A
into your computer’s AC
input. Insert the UPS cord’s male plug into any of
your UPS’s female output receptacles.
3. Insert the female plug of your computer’s cord
B
into your UPS’s AC input. Insert the male plug
of your computer’s cord into your AC outlet.
2
Plug your equipment into your UPS.
Your UPS is designed to support only computer
equipment. You will overload your UPS if you connect
household appliances, laser printers or surge
suppressors.
Cords and receptacle adapters are available
from Tripp Lite to accommodate most outlet
configurations. If rewiring is necessary, refer to the
Wire Color-Code Chart at the bottom of the page.
–Optional DB9 Connection*–
Using Tripp Lite cable, connect the serial port of
your computer to the serial port of your UPS. Load
software and run installation program appropriate to
your operating system.
*Your UPS will function properly without this connection.
3
Turn your UPS ON.
Set the System Enable Switch (UPS back panel) to
“ON” (or “ENABLE/I”)
3a
. This switch activates the
battery charger and microprocessor. The
“ ” light will flash until you engage the ON/Standby
Switch to activate the “ON” mode.
Engage the momentary ON/Standby Switch (UPS
front panel) and release it to activate the “ON” mode
and supply power to the UPS receptacles
3b
.
NOMINAL
SEE MANUAL
NOMINAL
SEE MANUAL
1
2
3a
3b
A
B
Wire Color Wire 1 Wire 2 Wire 3
American
Black White Green
European
Brown Blue Green/Yellow
Wire Reference Wire 1 Wire 2 Wire 3
American
Line 1 Neutral Ground
European
Line 1 Line 2 or Neutral Ground
Black Brown
White Blue
Green Green/
Yellow
AMER EURO
18-08-320-932202.indb 3 5/13/2019 2:55:53 PM
Loading ...
Loading ...
Loading ...