Loading ...
Loading ...
Loading ...
en Trouble shooting
28
--------
:Warning – Risk of injury!
Incorrect repairs are dangerous. Do not attempt to
repair the appliance yourself. Repairs must only be
carried out by one of our trained after-sales engineers. If
the appliance is defective, call the after-sales service.
:Warning – Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be
carried out and damaged power cables replaced by
one of our trained after-sales technicians. If the
appliance is defective, unplug the appliance from the
mains or switch off the circuit breaker in the fuse box.
Contact the after-sales service.
Error messages on the display
If an error message with "“" appears on the display,
e.g. “‹†-„ƒ, touch the v button. This will reset the
error message. Reset the time, if necessary.
If the fault was a one-off, you can continue to use your
appliance as normal. If the error message appears
again, call our after-sales service and quote the exact
error message and the E no. of your appliance.
~ "Customer service" on page 29
Maximum operating time
If you do not change the settings on your appliance for
several hours, the appliance will stop heating
automatically. This prevents unintentional continuous
operation.
When the maximum operating time is reached depends
on the various different settings that have been
configured on the appliance.
Maximum operating time reached
”‰ appears on the display.
Turn the function selector to the "Off" position. You can
configure new settings if required.
Tip: To prevent the appliance from switching off when
you do not want it to, e.g. with an extremely long
cooking time, you should always set a cooking time.
The appliance will heat up until the set cooking time has
elapsed.
The settings on
the appliance
cannot be config-
ured. A key sym-
bol has lit up on
the display or
†‘”“.
The child-
proof lock is
activated.
Deactivate the childproof lock by
pressing and holding the button
with the key symbol for approx. 4
seconds.
After an operating
mode is switched
on, œ is flashing
on the display.
The appliance
has not
cooled down
sufficiently.
Switch off the appliance, allow it
to cool down and switch on the
operating mode again.
The "descale"
symbol appears
in the display.
~ "Getting to
know your
appliance"
on page 8
Build-up of
limescale in
appliance.
Run the descaling programme in
full. ~ "Cleaning function"
on page 23
’‚Ÿ appears in
the display.
The power
supply has
been discon-
nected or the
appliance has
been
switched off
during the
descaling pro-
cess.
Run "Descaling interrupted" in
full. ~ "Cleaning function"
on page 23
“†‚-ƒƒ
appears in the
display.
There is too
much water in
the steam
system. The
water cannot
be pumped
back into the
water tank.
Empty the water tank then insert
it. Touch the v button. Reset the
time. Switch off the appliance and
switch it back on again. Run "Des-
caling interrupted" in full.
~ "Cleaning function"
on page 23
The appliance is
not heating. The
colon is flashing
on the display. On
some appliances,
a š will also
appear on the dis-
play.
Demo mode
is activated.
Briefly disconnect the appliance
from the mains (switch off the cir-
cuit breaker in the fuse box) and
then deactivate demo mode
within approx. 5 minutes by
changing the basic setting ™‚„
or ™› to ‹. ~ "Basic settings"
on page 18
Home Connect
does not work
correctly.
Go to www.home-connect.com
Loading ...
Loading ...
Loading ...