Loading ...
Loading ...
Loading ...
OPERATING YOUR HEATER (Electronic display model)
6.5 Copying a 24-hour program
•If the same 24 hour program works for several days in the week, just copy the program into
corresponding days
•Enter or find the 24-hour program you would like to copy
•Press the Copy button (10). The word “Copy” will be shown. The “day” will flash as well
•Press the timer button (11) to display the day onto which you would like to copy the program. The day
will flash
•Press the copy button (10) to complete the operation. The word “Copy” will disappear from the display
and the day will stop flashing. Repeat this operation to copy the program onto another day. Press the
Copy button (10). The word “Copy” is displayed and the day flashes
6.6 Terminate the week’s program
•Press the programming button (8) again to terminate the week’s programs. The control panel will now
show the correct, program type “UP”, the temperature, corresponding red or green light, and the program
sequence for the present day. The program is now active and running in “real-time”. The program
information is stored and will be lost when a factory-set program is used.
6.7 Altering the user program for the week
•Display the UP program type if another program is operating. See above for how to select the program
•Press the programming button (8) to open the program
•Make the required alterations as explained in sections 6.1-6.5 about programming. You have to alter the
complete 24-hour program
7. Adjust the temperature of a running program for the week
The temperature of the temperature sensor is relative to the position of the heater in the room. If the
actual temperature is higher than the setting, you can compensate this by adjusting the temperature
setting. For example, if the comfort temperature is set at 24
o
C but the actual room temperature is 26
o
C
compensate for this by lowering the setting to 22
o
C. Similarly increase the temperature setting if the
actual room temperature is lower than the setting. Note: do not make these adjustments if the
temperature is stable.
Press temperature button (13). The temperture setting and comfort symbol flash. Use the up and down
arrows to adjust the temperature to your desired setting.
Press the temperature button (13) again so that the economy symbol is displayed. Adjust the economy
temperature in the same way.
Terminate by pressing the temperature button again. The heater will revert to the last selected program.
8. Temperature Switch
Press the button (13) for more than 3 seconds, the temperature can be switched between Fahrenheit (F)
and Celsius temperature (C). The default setting is Celsius temperature.
Loading ...
Loading ...
Loading ...