Loading ...
Loading ...
FREE STANDING
1. Ensure the heater is unplugged and power switches are off.
2. Set heater upside down.
3. Locate the four holes at each end of the base of the heater.
4. Secure the foot plates to the base using the provided one-way screws through these holes.
Please note once these one-way screws are in they cannot be removed.
5. Set heater upright and plug into a standard 240 volt AC electrical outlet.
WALL MOUNTED
1. Make sure the heater is unplugged and power switches are off.
2. Position the panel heater within one metre of a wall socket. Do not mount in front of or below the
wall socket. Ensure there is at least 150mm clearance on all sides of the heater.
3. Detach the mounting bracket from the back of the panel heater by unscrewing the two locking
screws (located on the top of the mounting bracket).
4. Position the mounting bracket on the wall and mark the hole positions with a pen or pencil and
check they are horizontal with a spirit level. Ensure the two bottom mount holes are at least
150mm from the floor and drill holes as required.
5. Secure the mounting bracket to the wall with the four mounting screws. (For masonry walls use
the plastic sheaths).
6. Slot the back of the heater onto the mounting bracket locating the bottom plugs first and secure
with two locking screws.
7. Plug heater into a standard 240 volt AC electrical outlet.
Free Standing
Wall Mounted
150mm
150mm
150mm
Wall Mounting Position
Loading ...
Loading ...
Loading ...