Loading ...
Loading ...
Loading ...
ENGLISH
2
4
Connect Spray Wand to
SprayGun
Thread the spray wand into the end of
the spraygun.
5
Connect QC Nozzles to
SprayWand
Pull quick connect coupler back and
insert nozzle. Release quick connect
coupler and twist nozzle to make sure
it is secure incoupler.
6
Turn Water Faucet
CompletelyOn
Do not run the unit without water
supply connected and turned on. Use
Cold WaterOnly.
7
Release Air from System
Release all air from pump and high
pressure hose by depressing trigger
until a steady stream of water is
present. Approximately 30seconds.
8
Verify the Engine Switch is
turned to the ON Position
9
Place the fuel valve lever in
the ONposition.
30 S
OFF
ON
10
Move the choke to the
CLOSEDposition
11
Pull the Recoil Starter Grip
Pull the recoil starter grip to start
theengine.
12
Move the choke to the
OPENposition
WARNING: This Guide is not a substitute for reading the operator’s manual. User must read and understand operator’s
manual before using thisproduct.
Engine
Refer to the engine instruction manual for location and operation of other enginecontrols.
Pump
The Pump was filled with oil at the factory. The preferred oil is SIMPSON® Premium Pump Crankcase Oil. If this oil is not
available, an SAE 15W-40 oil may be used. Change the pump oil after the first 50hours of operation and every 100 hours
thereafter, or every 3months.
NOTICE: The pump was shipped with a shipping plug. The shipping plug MUST be removed and replaced with the
dipstick or vented cap (supplied). Running the unit WITHOUT removing and replacing the shipping plug with the dipstick
or vented cap (supplied) may cause damage to the pump and will void the warranty.
Loading ...
Loading ...
Loading ...