Loading ...
Loading ...
Loading ...
8
Installation
Extender Kit with Transceiver Installation
Notes:
1. The below installation diagram and instructions are for an HDBaseT HDMI over Cat5 Extender Kit
installation, though installation will be similar if you purchase the transmitter and receiver units
separately.
2. See the Product Features section of this manual for models compatible with your transceiver and
for information on the maximum supported distances and resolutions for your model.
3. Although transceiver units transmit RS-232 serial and IR Control signals from the transmitter to
the receiver, they do not feature their own RS-232 and IR Control ports.
4. Test to make sure the entire installation works properly before pulling cables through ceilings/walls.
5. To achieve maximum distance and performance, use 24 AWG solid wire Cat5e/6 or 23 AWG solid
wire Cat6a cable. Using stranded wire cable or cable with a gauge (AWG) size higher than that
recommended will result in a shorter extension distance. Higher gauge cabling such as 26 AWG
has a more limited transmission capability than lower gauge cabling. All Tripp Lite N202-Series
Cat6 cables are made with 24 AWG solid wire cabling. Extended lengths of 23 AWG solid wire
Cat6a cable is available from Tripp Lite as a custom order.
6. When using a 28 AWG HDMI cable and displaying video resolutions higher than 1080p, the HDMI
cables connecting the source and the monitor must not exceed 6 feet (1.8 m). When using a
24 AWG HDMI cable, you must not exceed a 16-foot (5 m) length.
7. Each kit includes one set of IR-IN and IR-OUT cables. It is up to the user to determine whether
the cables will be used to extend an IR signal from the transmitter side to the receiver side, or the
receiver side to the transmitter side. In most installations, the cables will be used to control the
HDMI source (e.g., Blu-ray player) from the same location as the monitor connected to the receiver.
HDMI Cable
Remote
Receiver
HDMI Cable
RS-232
Serial
IR-OUT
IR-IN
Blu-ray Player
Local
Transmitter
RS-232
Serial
IR-OUT
IR-IN
Bar Code Scanner
or Touch Screen
Connect
up to 4
Transceivers
Flat Panel
Computer
1. Make sure the HDMI source and RS-232 serial source is powered off.
2. Connect the HDMI source to the HDMI Input port on the local transmitter unit.
3. Connect the included 3.5 mm male-to-DB9 female adapter cable to the RS-232
port on the local transmitter unit, then connect the computer to the adapter.
18-11-133-933418-EN.indd 8 11/15/2018 10:35:34 AM
Loading ...
Loading ...
Loading ...