Loading ...
Loading ...
Loading ...
26 WWW.SENIXTOOLS.COM
1. Switch the product off.
2. Attach the guide bar cover.
3. Always carry the product by its handles.
4. Protect the product from any heavy impact or strong
vibrations which may occur during transportation in
vehicles.
5. Secure the product to prevent it from slipping or
falling over, loss of fuel, damage and injury.
1. Attach the guide bar cover.
2. Store the machine out of reach for children and
other unauthorized persons in a well-ventilated, dry
and frost-free environment.
3. Protect the machine against dust.
Waste product should not be disposed of with
household waste. Please recycle where facilities exist.
Check with your local authority or retailer for recycling
advice.
Suspected malfunctions are often due to causes that
the users can fix by themselves. Therefore check the
product using this section. In most cases the problem
can be solved quickly.
Only perform the steps described within these
instructions! All further inspection, maintenance and
repair work must be performed by an authorized service
center or a similarly qualified specialist if you cannot
solve the problem yourself!
Engine does not start
2.Spark plug gap is incorrect
3. Out of fuel.
4. Water in fuel.
5. Spark plug is damaged.
6. Spark plug connector loose.
2.Set the gap between electrodes a 0.027-0.031in.
(0.7-0.8 mm).
3. Fill fuel tank.
gasoline.
5. Replace spark plug.
6. Attach properly.
continuously until carburetor clears itself and install air
Engine stops 1.Out of fuel. 1. Fill fuel tank.
or loses power
1. Dirt, water or stale fuel in the
tank.
3.Vent hole in fuel tank cap is
clogged.
fuel.
3. Clean or replace the fuel tank cap.
Excessive
Vibration
1.Saw chain is damaged.
2.Bolts/nuts are loose.
1. Replace chain.
2. Tighten bolts/nuts.
Engine overheats 1.Air vent are clogged.
2.Spark plug gap is incorrect
3.Saw chain is blocked with
debris.
1.clean the air vent.
2.Set the gap between electrodes at 0.027-0.031in.
(0.7-0.8 mm).
3.Remove the blockage.
Loading ...
Loading ...
Loading ...