Loading ...
Loading ...
Loading ...
_EMENTO_
Before Setting Oven Controls
Element On and Hot Surface Indicator Lights
@
Your range is eq uipped with two different surface control lights that willglow on your range-- the
Element On indicator light and a Hot Surface indicator light. The Element On located on the
control panel, will glow when any surface element is turned on. A quick glance at this light after
cooking is an easy check to be sure all surface controls are turned off. The Hot Surface indicator
light, located on the control panel, will glow as the surface cooking area heats up and will REMAIN
ON until the glass cooktop has cooled to a MODERATE level.
Setting Surface Controls
To Operate Single Radiant Surface Elements
H_ SURFACE
1. Place correctly sized cookware on the radiant surface element.
Push in and turn the surface control knob in either direction to the desired setting. Start most
cooking operations on a higher setting and then turn to a lower setting to finish cooking. The
surface control knobs do not have to be set exactly on a particular mark. Use the marks as a
guide and adjust the control knob as needed. Each surface element provides a constant amou nt
of heat at each setting. A glowing red surface heating area extending beyond the bottom edge
of the cookware indicates the cookware is too small for the surface heating area.
2.
When cooking iscompleted, turn the surface element off before removing the cookware. Note:
the Element On indicator light will glow when one or more elements are turned on.A quick glance
at the indicator light(s) when cooking is finished is an easy check to be sure all control knobs
are turned off. The Hot Surface indicator light will continue to glow AFTER the control knob is
turned to the "Off" position and will glow until the heating surface area has cooled sufficiently.
3.
@
To Operate Simmer Select Surface Element (If equipped)
The right side of the control knob allows you to use the Simmer Select element as you would any normal surface element on
the medium to high settings.
The left side of the control knob isused to operate the Simmer Select feature. This feature allows the element to heat at a much
lower temperature than when used as a normal surface element. This allows you to precisely simmer delicate foods.
You may switch between normal cooking and Simmer Select at any time during the cooking process. Be sure to set the knob
indicator between MAX and MIN for simmering or between MED and HI for normal cooking.
NOTE: The element will not operate ifthe knob is positioned in the space between MAX and MED.
SIMMER _ELE_
L_Fr OOO
FRONT@ O
Simmer Select Radiant Surfacm Control
The suggested settings found in the chart below are based on cooking in medium-weight
aluminum pans with lids. Settings may vary when using other types of pans.
STANDARD SURFACE ELEMENTS
Setting Type of Cooking
HIGH (HI - 9) Start most foods, bring water to a boil, pan broiling
MEDIUM HIGH (7 - 8) Continue a rapid boil, fry, deep fat fry
MEDIUM (5 - 6) Maintain a slow boil, thicken sauces and gravies, steam vegetables
MEDIUM LOW (2 - 4) Keep foods cooking, poach, stew
LOW (LO - 1) Keep warm, melt, simmer
SIMMER SELECT SURFACE ELEMENT (If equipped)
MAX Larger quantities of food, stews and soups
MIN Smaller quanitites of food, delicate foods, melting chocolate or butter
Radiant surface elements may appear to have cooled after they have been turned off. The glass surface may
still be hot and burns may occur if the glass surface is touched before it has cooled sufficiently.
Do not place plastic items such as salt and pepper shakers, spoon holders or plastic wrappings on top
of the range when it is in use. These items could melt or ignite. Potholders, towels orwooden spoons could catch fire if placed
too close to the surface elements.
8
Loading ...
Loading ...
Loading ...