Loading ...
Loading ...
Loading ...
10 Customer Care Center +1 (800) 732-2677
Set Up the Threshold Transmitter
To prevent an unintended stimulation, never perform the setup procedures while your pet is wearing the receiver collar.
1. Turn over the threshold transmitter and remove the battery door. Install four AAA alkaline batteries
(2A) and replace the battery door.
2. Slide the switch on the back of the threshold transmitter to training mode until your dog has
learned his boundary.
Turning the Threshold Transmitter On
Turn the threshold transmitter right side up. Press and hold the mode button until the green LED light is
on. Release the button and the green LED light turns off. The red LED light will then flash the transmitter
level setting (between 1 and 4 times).
Turning the Threshold Transmitter Off
Press and hold the mode button until the green LED light turns off.
Setting the Transmitter Levels
Momentarily press and release the mode button. The green LED light will flash when pressed. The current setting will flash red. Press the mode
button again within 5 seconds. The level will increase by one level. If the current level is 4, it will revert back to level 1.
Step
2
2A
Loading ...
Loading ...
Loading ...