Loading ...
Loading ...
Loading ...
9
ENGLISH
Fig.F
8
7
Worklights (Fig. F)
CAUTION: Do not stare into worklights. Serious
eye injury could result.
There are three worklights
8
located around the chuck
collar
7
. The worklights will be activated when the trigger
switch is squeezed.
The beam will automatically turn off 20 seconds after the
trigger switch isreleased.
NOTE: The worklights are for lighting the immediate work
surface and are not intended to be used as a flashlight.
Proper Hand Position (Fig. E)
WARNING:To reduce the risk of serious personal
injury, ALWAYS use proper hand position as shown.
WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
suddenreaction.
Proper hand position requires one hand on the main
handle
12
and one hand on the battery pack. Hold tool
firmly with both hands to control the twisting action of
thescrewdriver.
Fig.D
1
2
• To select reverse, depress the forward/reverse control
button on the left side of the tool.
NOTE: The center position of the control button locks the
tool in the off position. When changing the position of the
control button, be sure the trigger is released.
NOTE: Continuous use in variable speed range is not
recommended. It may damage the switch and should
beavoided.
NOTE: The first time the tool is run after changing the
direction of rotation, you may hear a click on start up. This is
normal and does not indicate a problem.
Fig.E
12
Variable Speed Trigger and Forward/
Reverse Control Button (Fig. A)
The tool is turned on and off by pulling and releasing
the variable speed trigger
3
. The farther the trigger is
depressed, the higher the speed of the tool. Your tool is
equipped with a brake. The chuck will stop as soon as the
trigger switch is fullyreleased.
A forward/reverse control button
4
determines the
rotational direction of the tool and also serves as a
lock-offbutton.
• To select forward rotation, release the trigger and
depress the forward/reverse control button on the right
side of the tool.
Performing an Application (Fig. A)
WARNING: To reduce the risk of personal
injury, ALWAYS ensure workpiece is anchored or
clampedfirmly.
WARNING: Always wait until the motor has come to
a complete standstill before changing the direction
ofrotation.
Prior to performing work:
• Install the appropriate bit or accessory into the chuck.
Refer to Quick-Release Chuck.
WARNING:
• Do not use this tool to mix or pump easily
combustible or explosive fluids (benzine,
alcohol,etc.).
• Do not mix or stir flammable liquids
labeledaccordingly.
Loading ...
Loading ...
Loading ...